Star Delta Starter Wiring PLC Program:
This diagram shows how to Star Delta Starter Wiring PLC Program. In this post, we want to describe how PLC works. PLC is a Programmable Logic Controller. A PLC is a device that can easily control other devices, in some cases, it works as a substitute for a microcontroller. The difference between Microcontroller and PLC is that Microcontroller requires programming but in PLC the task can be done easily through a ladder diagram. It basically works similarly to a microcontroller but its main difference with a microcontroller is that it is used to control high-power controlling systems in the industry whereas a microcontroller is used to control low-power and precision control systems.
Diagram of Star Delta Starter Wiring PLC Program wiring:
 |
| Fig 1:Â Star Delta Starter Wiring PLC Program |
Components Need for this Project:
You can get the components from any of the sites below:
Read Also:
Components used to make the Project_name:
01. PLC
 |
| Fig 2: PLC |
PLC is a Programmable Logic Controller. A PLC is a device that can easily control other devices, in some cases it works as a substitute for a microcontroller. The difference between Microcontroller and PLC is that Microcontroller requires programming but in PLC the task can be done easily through a ladder diagram. It basically works similar to a microcontroller but its main difference with a microcontroller is that it is used to control high-power controlling systems in the industry whereas a microcontroller is used to control low-power and precision control systems.
02. 3 Phase Motor
 |
| Fig 3: 3 Phase Motor |
A Three-Phase Motor is an Electric Motor That Typically Receives its Power From a Three-Phase System (three-phase current) This can be realized via a Three-Phase Mains Supply or a Frequency Inverter. Three-Phase Motors are Available as Synchronous and Asynchronous Motors. Three Phase Alternating Current Power Motor is Economical to Supply Power to the data Center Since it Requires Less Conductor Material to Supply Electricity. This Explains Why 3 Phase Alternating Current Motor is Used in Electric Transmission, Generation, and Distribution in Most Countries Worldwide.
03. Contactor
 |
| Fig 4: Contactor |
A magnetic contactor is an electrical device used for load control, automation, and protection. It is much like a magnetic reel. However, relays are generally used for low power and voltage, on the other hand, when we think of high power, these heavy-duty contractors only come to mind. It basically works by switching the load on and off. It has 3 terminals whose inputs are denoted as L1, L2, L3, and outputs as T1, T2, and T3. The circuit of the load is made in automation mode or protection using auxiliary contacts. It has two types of terminals. 1) Normally Open (NO). 2) Normally Closed (NC).
Thank You for visiting the website. Keep visiting for more Updates.
Post a Comment
Do leave your comments