3 phase motor star wiring | 3 phase motor connections

3 Phase motor Star Wiring:

This diagram shows how to connect 3-Phase Star Motor Wiring. In this circuit diagram, we just try to describe simply how to connect a 3-Phase Star delta Motor Wiring Industrial loads like. Line voltage and phase voltage are the same in a star connection, and the line current is equal to √3 times the phase current. Hence, for both delta and star connections.

Diagram of 3 Phase motor connections:

Fig 1: 3 phase motor star wiring

Components Need for this Project:

You can get the components from any of the sites below:

1. 3 phase Motor [See Buy Click Amazon]
2. Magnetic Contactor [See Buy Click Amazon]
3. No Switch [See Buy Click Amazon]
4. Nc Switch [See Buy Click Amazon]

*Please note: These are affiliate links. I may make a commission if you buy the components through these links. I would appreciate your support in this way!

Read Also:

• Timer Switch for Street Light

• Voltmeter Connection Diagram

• 3-phase voltmeter selector switch connection

• Street light sensor wiring connection

• On-delay Timer Connection

Components used to make the 3 phsse Motor Connections:

01. 3-Phase Motor

Fig 2: 3 Phase Motor

A Three-Phase Motor is an Electric Motor That Typically Receives its Power From a Three-Phase System (three-phase current) This can be realized via a Three-Phase Mains Supply or a Frequency Inverter. Three-Phase Motors are Available as Synchronous and Asynchronous Motors. Three Phase Alternating Current Power Motor is Economical to Supply Power to the data Center Since it Requires Less Conductor Material to Supply Electricity. This Explains Why 3 Phase Alternating Current Motor is Used in Electric Transmission, Generation, and Distribution in Most Countries Worldwide.

02. Magnetic Contactor

Fig 3: Magnetic Contactor

A magnetic contactor is an electrical device used for load control, automation, and protection. It is much like a magnetic reel. However, relays are generally used for low power and voltage, on the other hand, when we think of high power, these heavy-duty contractors only come to mind. It basically works by switching the load on and off. It has 3 terminals whose inputs are denoted as L1, L2, L3, and outputs as T1, T2, and T3. The circuit of the load is made in automation mode or protection using auxiliary contacts. It has two types of terminals. 1) Normally Open (NO). 2) Normally Closed (NC)

03. No Switch

Fig 4: NO Switch

The operator switch has its contact in Normally Open condition. To make Ladder Logic you need to understand NO contact. A Classic Switch has one Input And one Output. In "No Switch," YoungBoy Raps About Ammunition, Murder, Firearms, and Firearm Attachments Such as a Switch. The contact of the switch whose contact is already open is NO. That is enough to understand. no switch in a circuit, then the circuit will not function as intended. to write a program such that when the red light is on, This switch is now in normally open condition. When you push the switch it will close and the red light will turn on.

04. NC Switch

Fig 5: NC Switch

Indicates the contacts of switches or automatic actionable devices. Simply put, the push switches, magnetic contactors, and relays that we use in the factory Normally have Close Contact exists. At this moment the switch will be in normally closed condition. Because already he is sitting close. When turned off the contact will open. To make ladder logic you need to understand NC contact. As already explained. The switch contact is already closed in NC. That is enough to understand.

Thank You for visiting the website. Keep visiting for more Updates.